You are currently reviewing an older revision of this page.
To report the reinforcing pad in the generated isometrics using schema customization in the OpenPlant Isometrics Manager
By default, OpenPlant Isometrics Manager does not report the reinforcing pad in the generated output of the OpenPlant Isometrics Manager and is not included in the Bill of Materials. We need to make some schema changes to achieve that. The changes mentioned in the schema allow us to achieve both the requirements.
End Preparation “BW”
Size IM.ConvertUnit(this.NOMINAL_DIAMETER,IM.GetUnit(this.GetClass().Name,"NOMINAL_DIAMETER"),IMPROJ.BORE_UNIT)
Location X IM.ConvertUnit(this.P1_X,IM.GetUnit(this.GetClass().Name,"P1_X"),IMPROJ.COORD_UNITS)
Location y IM.ConvertUnit(this.P1_Y,IM.GetUnit(this.GetClass().Name,"P1_Y"),IMPROJ.COORD_UNITS)
Location Z IM.ConvertUnit(this.P1_Z,IM.GetUnit(this.GetClass().Name,"P1_Z"),IMPROJ.COORD_UNITS)
Orientation x “0”
Orientation y “0”
Orientation z “0”
End Type Id “1”
Convert location to wcs True
Convert direction to wcs False
*Note: Copy the above variables in the notepad and then paste in the schemas.
If the above problem persists, then please create a Service Request and contact the Bentley Product Advantage group. Please include a list of all relevant details to get in depth analysis for a solution or workaround.
Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!