To Obtain Pipe Bend Coordinates in OpenPlant Isometrics Manager

Overview

To obtain Pipe Bend Coordinates in OpenPlant Isometrics drawing

Problem Description

While extracting isometrics, it has been found that pipe bend coordinates are required to display on bends for specific use. This can be achieved using Isometric Configuration dialog, & defining a variable inside it. See below steps to verify the result.

Steps to Resolve

1. In OpenPlant Modeler, select any project and create an arrangement with multiple bends with different Radius.

2. Launch OpenPlant Isometrics Manager, using Isometric Configuration dialog à select user labels option.

3. Under Bend Radius and Bend Labels field, change value as shown in below.

   R=$(BEND_POINT_RADIUS)D$$(BANGLE)°$(COORD)
   
   Where,
   BEND_POINT_RADIUS = It gives Radius info

   BANGLE = gives an angle

   COORD = Give coordinates at intersection point.
   
   
   

4. Save option & Generate isometrics. See image below.
   
   
   
   
   
   

Still A Problem?

If above problem still persist, then please create a Service Request and contact Bentley Product Advantage group along with the list of all relevant details to get in depth analysis and for possible solution or workarounds. 

See Also

Comments or Corrections?

Bentley's Product advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!