08.11.09.XXX (SS5) | 08.11.11.XX (SS6)
To generate spool id for components with hub end preparation in OpenPlant Modeler.
In OpenPlant Modeler, spool Id constitutes of the SPOOL_PREFIX, defined on the pipeline, and a number at the end that uniquely identifies that spool in that particular pipeline.
By default in OpenPlant Modeler, spool id splits whenever flange arrangement is found. Here requirement is to assign spool id for components with flanged ends as well as with hub ends. As shown in below image, our requirement is assign spool id based on hub ends.
As in above model arrangement, assigning spool id should split into three spool ids. Below wiki article explain, how to achieve this requirement.
Note: In this wiki article, changes are demonstrated for out of box setup of OpenPlant Modeler V8i for metric project.
If above problem still persist, then please create a Service Request and contact the Bentley Product Advantage group. Please include a list of all relevant details to get in depth analysis for a solution or workaround.
Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!