You are currently reviewing an older revision of this page.
Document Type: TechNote Product(s): Drawing Flattener Version(s): 08.09.02.02, 08.09.03.30, 08.11.05.36 Original Author: Bentley Plant Technical Support Group; Richard DeLong
Document Type: TechNote
Product(s): Drawing Flattener
Version(s): 08.09.02.02, 08.09.03.30, 08.11.05.36
Original Author: Bentley Plant Technical Support Group; Richard DeLong
When running Flattener, if the current layer is locked, flattener will not flatten the drawing. It will run, but place nothing from model space into the flattened drawing. This applies to all versions of Drawing Flattener, be it XM or V8i.
To fix this issue, make sure that the current layer is not locked. It usually is a good idea to use the 0 layer as your current layer and leave it unlocked, since most AutoPLANT programs don't typically write to the 0 layer.
Product TechNotes and FAQs
Plant TechNotes And FAQs
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!