In OpenPlant Modeler CONNECT Edition, requirement is to turn-off PlantSight Differences dialog.

Background

In OpenPlant Modeler CONNECT Edition, upon performing PlantSight Check-in operation for OpenPlant 3D data, it shows the PlantSight Differences dialog as shown below.

Here requirement is to turn-off this dialog. Below wiki article explains the procedure that will meet such requirement.
Note: For this exercise, OpenPlant Modeler CONNECT Edition workset should be associated with PlantSight Project.

Steps to Accomplish

1. Launch OpenPlant Modeler CONNECT Edition.
   
   
   
   
2. From desired workspace/workset, open a model file.
3. From Backstage window, select Settings > Configuration > Configuration Variables as shown below.
   
   
   
   
4. From Configuration Variables dialog, click on New to define a new variable. Refer image below.
   
   
   
   
5. Under New Configuration Variable Dialog, enter Variable name as “OP_SuppressCommitPrompts” & New Value as Refer image as shown below.
   
   
   
   
6. Once done click on
7. Click on OK From Alert prompt, select Yes to save the changes, refer image below.
   
   
   
   
8. Close OpenPlant Modeler CONNECT Edition & open it again.
9. For desired model file, select PlantSight > Check-in All operation as shown below.
   
   
   
   
10. Notice that once variable has been evoked, no PlantSight Differences dialog can be seen & all OpenPlant 3D model data checked-in to PlantSight portal. In message bar we can see the status of our check-in operation.
    
    

See Also

Still a Problem?

If above problem still persists, then please create a Service Request and contact the Bentley Product Advantage group.  Please include a list of all relevant details to get in depth analysis for a solution or workaround.