The Wiki will illustrate in how to fix no weld issue that occurs when placing a Thredolet. This is due to a missing field in Specs. Follow below to know the steps.
.
1. Identifying Source: As seen below it should also show “Fluid Port” info in the Spec window before Placement (when multiple records).
Instead it shows only “End Preparation”.
2. Open Spec MDB, go to Design View for OLET table and add END_COND_3 as shown below.
3. Keep the END_COND_3 Empty/Blank.
4. Save the Spec and reopen OpenPlant Modeler to try again.
5. The weld will now occur.
How to get Co-ordinate Values in Meters in Iso Output via OPIM Applies To OpenPlant CONNECT Edition Product(s): OpenPlant Isometrics Manager Version(s): CONNECT EDITION (10.07.00.32) Environment: Windows 8.1/10 (64 bit) Area: Configuration… Last edited 6 months ago in OpenPlant | AutoPLANT > OpenPlant | AutoPLANT Wiki
If above problem still persists, then please create a Service Request and contact the Bentley Product Advantage group. Please include a list of all relevant details to get in depth analysis for a solution or workaround.
Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!