Background

When there is a requirement in which the precision must be set for Pipe Bend Angle in Isometrics Output, this wiki would be helpful in achieving the desired result.

Steps to Accomplish

1. Open Isometrics Configuration inside OpenPlant Isometrics Manager CE and modify labels like shown below.
   R=$(BRADIUS:#.0)$$(IE_BANGLE:#.0)°
   Here, it means 1 digit after Decimal Point.
   
   
   
   For Example, (IE_BANGLE:#.##) means 2 digits after Decimal Point and so on.
   
   
2. Save and Close OPIM Configuration.
   
   
3. Open OpenPlant Modeler CE and Generate Isometric Output to get the Desired Result.
   
   

See Also

Still a Problem?

If above problem still persists, then please create a Service Request and contact the Bentley Global Technical Support Group.  Please include a list of all relevant details to get in depth analysis for a solution or workaround. 

Comments or Corrections?

Bentley's Global Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!