Applies To
Product(s):	OpenPlant Modeler
Version(s):	CONNECT Edition (10.11.00.260) & Above
Environment:	Windows 10/11 (64 bit)
Area:	Joint
Subarea:	Flanged Joint / LUG Joint
Original Author:	Chanchal Mashalkar, Bentley Global Technical Support

Problem Description

There are multiple reasons of showing Incorrect Bolt Length. In this Example user has defined the Flanged as End Preparation for the Lug Joint in both the places shows incorrect bolt length as shown in the image below.

       

Below are the steps to resolve this kind of issue.

Steps to Resolve

1.  Launch Bentley Class Editor
   
   
2. Open OpenPlant_3D.01.08.ecschema an Supplement it with OpenPlant_3D_Supplemental_Modeling.01.08.ecschema & OpenPlant_3D_Supplemental_ModelingViews.01.08.ecschema.
   
3. Find for Joint Class and search join type as Lug Joint shown in the image below.
   
   
   
   
4. Remove Flange from one of the End Preparation and save all the changes.
   
                         
   
   
5. Relaunch the OPM and verified the result.
   
   
   
   
   Reason: Lug Joint Contains Flange End Preparation which was defined at both the the places typically one should have at one end only
   
   
   
   

Still a Problem?

 If above problem still persists, then please create a Service Request and contact the Bentley Product Advantage group.  Please include a list of all relevant details to get in depth analysis for a solution or workaround.

Bentley's Global Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!