| Applies To | |
| Product(s): | OpenPlant PID |
| Version(s): | 08.11.12.13 |
| Environment: | Windows 10 (64 bit) |
| Area: | Synchronization |
| Subarea: | - |
| Original Author: | Fer Mykiel Gonzales, Bentley Technical Support Group |
Problem Description
When synchronizing, an error message may pop up that says:
When the Message Center is opened, the following error was caused by:
Steps to Resolve
1. Launch OPPID
2. Open DGN in your preferred workset
3. Open Key-in
4. Enter pid model regenguid
Note:
- this is not selective and may not apply to all piping components that have missing GUIDs
- if the piping components are still missing GUIDs, repeat the key-in
Caveat:
- This could cause issues downstream if you are using the current components in another software where you are relying on the GUID for component uniqueness
Still a Problem?
If above problem still persists, then please create a Service Request and contact the Bentley Global Technical Support. Please include a list of all relevant details to get in depth analysis for a solution or workaround.
Comments or Corrections?
Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU