| Applies To | |
| Product(s): | OpenPlant PID |
| Version(s): | CONNECT Edition 10.11.++ |
| Environment: | Windows 10/11 (64 bit) |
| Area: | Spec |
| Subarea: | |
| Original Author: | Nikitesh Kawana, Bentley Global Technical Support Group |
Overview
In OpenPlant PID/ Modeler sometimes user may face issue of Specs being not fetched due to different storage location of Specs.
Problem Description
In use workset, if specs are not fetched in OPPID or OPM, even if Specs and Catalogue folder is present, then this may be due to different storage location of Specs by user as described below
Steps to Resolve
- Open OpenPlant.cfg file Located at Workset level
- Search for OP_SPEC_DIR
- If there is Modified OP_SPEC_DIR is present than comment it out and comment IN the default one
- Save and Start Product again
See Also
Still a Problem?
If above problem still persists, then please log a Case and contact the Bentley Global Technical Support group. While logging a case, please include all relevant information to get in-depth analysis for a solution or workaround.
Link to log a case is available Here>>>
Comments or Corrections?
Bentley's Global Technical Support group requests that you please confine any comments you have on this Wiki entry to Forum section? section. THANK YOU!