I've just installed ver 08.11.08.228 (extension) on opening a dgn I get this error, but the file opens. Trying to place use GC element forces the program to close - attached is the error log.
any ideas?
Did you see the baseCS after you "opening a dgn I get this error, but the file opens" or just the active plane?
No baseCS just a blank workplane.
Robert,
Could you paste the dgn file here or send it to me xun.zhou@bentley.com so that I can see if I could recover it?
-Xun
I've emailed you the files.
same error with me. any solutions?
just made a check: switched back to 08.11.07.78 and everything works fine
And another check: I tried a clean install of .443 (not like before an update over .171)
and then installed GC .228 and it works
Maybe the same thing with you Robert?
I.