Batch processing with vba and standards checker

we are using MS ss1.

We have some vba rules for the standards checker and a default rule set loaded via a dgnlib every thing works from with in microstation.

when using batch processing to check many files everything runs but my vba rules are never called ? and are not reported as loaded inteh standards checker report.

I add my custom standard checkeler rules on a onloadproject vba event with a break point I can see it is called during batch processing but the rules are never see by microstation.

Does any one have any suggestions ?

Best Regards,

Ian Emery

Parents
  • I have made a custom VBA checker for standards checker as module but it seems that it is used only once. If I run checker and then reopen the checker dialog afterwards to run checker again the VBA rules are not there anymore. Problem seems similar to the original post.

Reply
  • I have made a custom VBA checker for standards checker as module but it seems that it is used only once. If I run checker and then reopen the checker dialog afterwards to run checker again the VBA rules are not there anymore. Problem seems similar to the original post.

Children
No Data