V8i VBA view attributes fill on/off or V8I Key-in

I know about Ctrl B and click them on or off, but since the following work in VBA '[1] new ActiveDesignFile.Views(1).DisplaysDataEntryRegions = False ActiveDesignFile.Views(1).DisplaysLineWeights = True ActiveDesignFile.Views(1).Redraw What would I put for the fill to be on or off? I did search through the key-in set fill and set view, but could not figure out how to do it I have a vba routine that sets most of my needs for each new drawing, but found this fill was my problem on more that one drawing, so I was going to attempt to remove the problem and turn it on?
Parents Reply Children
  • This what I used to see in the older help, but I tried twice and it went to make a new post and start over so I hit the back arrow at the top and got the message are you sure you want to leave this "reminded me of the FB commands" Should I try and get a snip of the screen I get? Will have to get back to this problem

    RJB Phillips III - Praise the Lord for His Mercy and Grace

  • Phil, unable to add the pictures. You do not the what  you showed and unable to post the two .jpg to show you any other possible suggestions? When I click the use rich formatting below, I go to another page, but there is no display in the quote section on only text like this <p> and then the text I just typed if I pick the option tab and try and load the picture it shows loaded but still will not display it.

    RJB Phillips III - Praise the Lord for His Mercy and Grace