Hi,
I am testing Manual Marking Tool and I can't load the Pad Footing into the Manager. It is possible for all other elements (Beams, Columns, Wall) but not for the Pad Footing. Could You check this out? I have version 10.06.01.59 of Prostructures.
fund1_test.dgn
Grzegorz Zwoniarkiewicz
Although I can load Pad Footing Reinforcing (with quantity option) to the Marking Tool Manager, I cannot load those rebars further into the Schedule Generator.
I tried this with Single Rebar Distribution and with Irregular Dispatch Reinforcing. None of the rebar assigned to Pad Footing can be loaded into the Schedule Generator. Could You include this problem in Bug Report 948910 ?
';width:125px;max-width:100%;max-height:44px'="" title="Telligent Community" class="" width="125" height="44"> Update from Bentley Communities [AUTOMATED MESSAGE; if there is a link below, please follow that if you wish to respond to this Communities message.] RE: Manual Marking Tool and Pad Footing Vyanktesh Nama Hi Grzegorz, Thanks for raising the service request as suggested. I would like to inform you that this issue resulted in Bug Report 948910, and will be evaluated by the product management team for our regular CONNECT Edition updates. Meanwhile I would recommend using following workflow: Instead of using spacing option, you could use the quantity option in the Pad Footing Reinforcing tool so that the rebars gets loaded into the Manual Bar Marks Manager. Did this answer your question? Verify it as the answer or Reject it as the answer View online You received this notification because you subscribed to the forum. To unsubscribe from only this thread, go here. Flag this post as spam/abuse.
[AUTOMATED MESSAGE; if there is a link below, please follow that if you wish to respond to this Communities message.]
RE: Manual Marking Tool and Pad Footing
Hi Grzegorz,
Thanks for raising the service request as suggested. I would like to inform you that this issue resulted in Bug Report 948910, and will be evaluated by the product management team for our regular CONNECT Edition updates. Meanwhile I would recommend using following workflow: Instead of using spacing option, you could use the quantity option in the Pad Footing Reinforcing tool so that the rebars gets loaded into the Manual Bar Marks Manager.
Did this answer your question?
Verify it as the answer or Reject it as the answer
View online
You received this notification because you subscribed to the forum. To unsubscribe from only this thread, go here. Flag this post as spam/abuse.