Object displaying wrong in 2D

Hello Curtis Mcguffee,

Thanks for posting this query in Bentley Community Forum.

I cannot comment anything at this moment without visiting the model. Could you please send us the model so that we can look into this and see if there is any cut existing?

Hello,

Thanks for reaching out.

I attached the dgn. This is occurring in the "ST-1 - 138KV 3-PH LOW BUS SUPPORT" model. I have the details split up by part families, this one is in the "Channel" part family.

Thanks,

Curtis

ST-1 - 138kV 3-PH Low Single Insulator Bus Support.dgn

Hello Curtis Mcguffee,

I have tested this issue and it is replicable when we insert channel part drawing in the 2D Design Model.

But the same drawing when we insert in the 3D Design Model then the drawing is displaying correctly, please refer to the below image.

We can understand that this should also work correctly in the 2D Design Model. So, we request you to please raise a service request for this issue so that we can log this issue in our system on your behalf. For more information on how to raise a service request, please follow the below wiki link.

Thanks Vyanktesh! I'll just use these in 3D models for now, thanks for finding a work around for this. Service Request # is 7001432278.

Thanks Vyanktesh! I'll just use these in 3D models for now, thanks for finding a work around for this. Service Request # is 7001432278.