Dear friends,
I have issue in my template the end condition ( fill and cut) not working properly when i go for cut the drainage profile should shown at of bottom the blanket but my template it not shown (picture 1) when i reach the level for 0,0 then only the drain profile is visible for (picture 2).
Picture:3 There was problem for when i'm going to the fill end condition of embankment the fill line was not visible while test the template.
How to resolve the issue please help me anyone ASAP.
picture:1
Picture:
Picture:3
Regards,
Boopathiraj
Your end condition components need to all originate from a common hinge point (per side). Use the point where the fill end condition component begins. The drain should be a part of the cut end condition component (not a separate component as you currently have). Give the fill component a priority of 1 and the cut component a priority of 2.