Ram Elements Retaining Wall - Propped/Pinned Wall

If the top and bottom of the wall is pinned, then the program assumes that the wall is laterally restrained at the top and bottom; therefore it is not going to slide.

OK, is there a way to have the bottom of the wall "not pinned" at the bottom?

Typically the wall is "pinned" at the top by a floor system. At the bottom there could be different conditions to resist sliding - friction, passive pressure or possibly a slab. Can the program check friction and/or passive pressure?

Is the bottom reaction reported somewhere?

Thanks!

Currently there is no way to do this. The program only designs cantilever or restrained walls. The bottom reactions is reported graphically in the analytical model tab by selecting the "Reactions" button under the analysis results.