Internal Error in AdvancedNodeList()

Question

I am getting this error when I try and run the steel and column module??? Can I send you my model to see if you can find the issue?

Seth Guthrie · Answer

Your issue is the common case, a floating elevator core.

Seth Guthrie · Answer

Seth Guthrie · Answer

These hip roofs with long slab edges using 0" slab offsets are tricky. I found that if I replaced the slab edge on the Low Roof level, East side, with one whole perimeter slab edge (4'9" offset), then it was OK. You can reduce the slab edge where you don't want such a large overhang afterwards, but keep it offset outboard at least 1". Alternatively use a small overhang all around and supplement the perimeter beams or walls with line loads.

Seth Guthrie · Answer

There are some intersecting walls that need to be split. I also see some slight variation in the coordinates.

Internal Error in AdvancedNodeList()

Top Replies