Inactive member command - GUI input

Dear Admin,

What is the way (in steps) to issue "inactive member command" through GUI not through STAAD(text) editor?

e.g. I have geometry defined and 3 load case. i want to have for each load  case different member to be inactive. what are the steps?

Best Regards,

Parents
  • The following screenshot explains how to assign INACTIVE member specification using the GUI

    If you have to define different set of inactive member specification for different load cases, you have to use the text editor and specify it the way shown below

    An example model demonstrating the use of different INACTIVE members for different load cases, is attached for your reference.

    EXAMP04.STD



  • Dear Sye,

    Still I don't know how to have the order in issued command. All inactive sets will come on the top of command list and change and perform analysis at the end. How to insert them between Load cases, but from graphical input(GUI)?

    Best Regards,

Reply
  • Dear Sye,

    Still I don't know how to have the order in issued command. All inactive sets will come on the top of command list and change and perform analysis at the end. How to insert them between Load cases, but from graphical input(GUI)?

    Best Regards,

Children