respected sir,
I am solving a simple supported beam of span 2m. Material = concrete. UDL of 10kN/m throughout the span (2m), but i am getting an error after running analysis.
i am getting an error " **ERROR- IN READING MEMBER PROPERTIES. CHECK DATA FORMAT CAREFULLY."
i am getting this error again and again after adding all the date correctly. Please guide me to correct this error.
DATA:
1. STAAD SPACEINPUT FILE: F:\SProV8i SS6\STAAD\Plugins\tutorial.STD 2. START JOB INFORMATION 3. ENGINEER DATE 22-MAR-18 4. END JOB INFORMATION 5. INPUT WIDTH 79 6. UNIT METER KN 7. JOINT COORDINATES 8. 1 0 0 0; 2 5 0 0 9. MEMBER INCIDENCES 10. 1 1 2 11. DEFINE MATERIAL START 12. ISOTROPIC CONCRETE 13. E 2.17185E+007 14. POISSON 0.17 15. DENSITY 23.5616 16. ALPHA 1E-005 17. DAMP 0.05 18. TYPE CONCRETE 19. STRENGTH FCU 27579 20. END DEFINE MATERIAL 21. MEMBER PROPERTY **ERROR- IN READING MEMBER PROPERTIES. CHECK DATA FORMAT CAREFULLY.
I have been having the same issue. Can you please advise how this issue was resolved?
Can you please upload the file here?
Doesn't allow me to upload the .upt file
Try making a Zip folder.
STAAD_BU_Section.zip
The sequential order of input file is not right. I have edited your file and now it is running good. But, I have noticed that you have used different sets of units all over places. I would request you to review all the units once again in editor file to make sure all are as expected. Please keep the STAAD and .upt in a same folder to run the attached file.
W361503099.zip
Thank you. Correct. Different units have been used. I'll look into it to ensure it's done right.
hello i have the same problem can you tell me what to do?
Please upload the .std file
5 Storey Plan.zip
Your zip file just contains one file with extension .slg. You need to upload the .std file and no need to zip the file.
5 Storey Plan.std