Dear Folks,
I am using STAAD.Pro CONNECT Edition, the trouble I am facing is while putting joint loads using GUI, staad takes erratic value automatically. E.g. if we input some value only as FY=10.50 but staad takes it as Fz=0.5, Mx=0.50, My=0.50, Mz=0.50, ref snap attached;
Similar troubles are with load on member.
If anyone is aware of the fix of this problem then please respond. Your response will be highly appreciated.
Thank you !
Hello, May I know which version of STAAD.Pro CE are in use? If it's not STAAD.Pro CE 21.00.02.43, I would recommend you to download the said version from http://select.bentley.com/FulfillmentCenter/en-us/ and install the same.If the problem persists even after having the recommended version installed, please upload your STAAD input file (STD)
Below link illustrates the process of File uploadinghttps://communities.bentley.com/products/ram-staad/w/structural_analysis_and_design__wiki/28129/how-can-i-upload-files-in-the-bentley-communities-forum
Thanks,BM
I am Using STAAD.Pro CONNECT Edition - Version 21.00.02.30
The problem is not file specific, this phenomena is occurring in any file.
Is there any document which spells flaws/limitations/bugs in STAAD.Pro CONNECT Edition - Version 21.00.02.30
Please install the recent STAAD.Pro CE 21.00.02.43 as I recommended before.