No members loaded for a floor load generated

Question

I am modeling a digester tank , there is a walk above the dome resting on rcc wall, to transfer the slab dead load and live load i have created dummy elements over the walls and applied the dead load and live load as floor loads by grouping the beams, the staad in the modeling mode it shows the load distribution of floor load but when I run the model the warring shows up saying , NO MEMBERS LOADED FOR A FLOOR LOAD GENERATED 
 Can i ignore the warning or is there some other way to transfer the dead load and live load to the walls without modeling the slab itself

Sye · Answer

Whereas the floor load generation would work for most of the panels but there are a few as marked below where the angles formed by the adjacent sides exceed 180 degree which is not suitable for a floor load generation. Instead of applying the load as floor load on these panels, I would suggest that you calculate the loads on the members and apply it using member loads for these panels. The floor load should work for the rest.