Hello everyone,
First of all, apologies if this was discussed before but i could not find the answer for this.
I have a question about wind load calculations in MSTower software. I just started to use MSTower and try to understand its logic. It is completely clear how to input the location parameters to MSTower to make it calculate the wind forces but after it calculates, i would like to check the wind pressure results from software with my hand calculation. Is there any section that i can see the calculated wind pressure in MSTower? So i can compare the wind and will be more comfortable when i continue my calculations.
Again, if it was discussed before, apologies for duplicating/re-opening the discussion. Thank you very much for your answer(s) in advance.