RAM Steel Beam Internal Error in AdvanceNodeList(), but I am not getting errors when I do a data check in the modeler

RE: RAM Steel Beam Internal Error in AdvanceNodeList(), but I am not getting errors when I do a data check in the modeler

Karl G — Mon, 27 Jan 2020 19:25:04 GMT

To eliminate the errors, segment walls like Wall #89 on the 2nd Floor Layout so that a wall end coincides with the tip of the extend cantilever of Beam #48 on the 1st Floor Layout. Examples of other affected locations are marked in the image below. The numbers in the image correspond to the wall numbers on the Second Floor. Beam numbers are not displayed in the image.

RE: RAM Steel Beam Internal Error in AdvanceNodeList(), but I am not getting errors when I do a data check in the modeler

Patrick Westerkamp — Mon, 27 Jan 2020 15:35:19 GMT

Thank you for the help! This solved my problem with the steel beam module. Although, I am having a problem with the concrete analysis. I have uploaded my latest model.

I am receiving a tolerance error and I am receiving the coordinates of the error but can not seem to fix the alignment issue. I have tried deleting the members and modeling them back, but it still doesn't work. Your help would be greatly appreciated. Thank you!

RE: RAM Steel Beam Internal Error in AdvanceNodeList(), but I am not getting errors when I do a data check in the modeler

Seth Guthrie — Thu, 23 Jan 2020 16:35:40 GMT

For this error refer to: https://communities.bentley.com/products/ram-staad/w/structural_analysis_and_design__wiki/4552/ram-ss-common-framing-table-errors-tn

In your case, see below.

RE: RAM Steel Beam Internal Error in AdvanceNodeList(), but I am not getting errors when I do a data check in the modeler

Patrick Westerkamp — Wed, 22 Jan 2020 22:50:08 GMT

I have also uploaded my file to Bentley Services.