Hello, I´m currently reviewing a Reinforced Building Design in STAAD.Pro CONNECT Edition and The Client asked for some information; more specifically, the Design Moments and Axial Forces for the RC Columns, so I went to look up the info in the Analysis Output (Attached Figure) and I find that, even though it shows the Design Load Case, the values reported are only strength values, as in: P0, Pnmax, P-bal, M-bal, e-bal, M0, P-tens, Des. Pn, Des. Mn ans e-bal. Aditionally, it shows the Interaction Diagram but only for the Strength Parameters (Pn and Mn for the different sections, I suppose). So my question is this: is there a way in which I can find the Axial Forces and Moments that were used in the Design of a given Column? And if there´s an even easier way to obtain the Design Forces and Moments for all of the Columns at once then that would be even, but that might be too much too ask for right now. Anyway, that´s the problem I´m facing at the moment, thanks in advance for any help and/or suggestions to my approach.