Hi All,
I was hoping someone can help me.
I am trying to perform a Finite Element Analysis of a Plate with a load on 100KN but the subject error stops the analysis.
I have searched but coudn't find the solution. Can anybody guide me please how to remove this error.
I have attached the document any help that you me be able to carry it will be much appreciated.
Thank you,
Ali
Hello,
It seems to be a modelling issue in the model. Please check if proper plate connectivity is there or not.
You may upload the file for investigation at our end also.
Some similar issues have been discussed in below link.
https://communities.bentley.com/products/ram-staad/f/ram-staad-forum/113813/error-joint-no-0-not-connected-or-duplicated
https://communities.bentley.com/products/ram-staad/f/ram-staad-forum/118303/staad-pro-error-memb-or-elem-no-0-does-not-exist