Error designing one or more section cuts

Question

Hi Seth, 
 In my RAM model error regarding section cuts are coming continuously. 
 As I need custom load combs. 
 Can you look into it?

Seth Guthrie · Answer

Probably the walls on the two stories are not perfectly aligned, or are both very slightly off the 90 degree plan axis. Try using the align walls command to force the walls into alignment better yet align them to a grid line, and recheck.

Seth Guthrie · Answer

Though everything appeared to be aligned, I was able to resolve it by adding grids, aligning to the wall ends to grids and then adjusting the grid over 1' and finally back. Regretfully this resets the WDG and section cut assignments. I'll send you the file I have edited, though it needs to be rerun for the right lateral loads and as well as resetting the WDG and section cuts for a few walls.