Good evening dear community,
I need your guidance regarding the launch and use of Ram connection interface.
Model designed in physical modeler and then analysed in analytical. As you can see on the below picture i selected the ''select all Beam-Column flange joints'' from ''select joints tab'' at the upper left side. Then i selected the smart connection and put the applicable design code where only one connection was available.. see the following pic.
.
I selected it and then the following message appeared.
What am i supposed to do in order to assign the connections?
Thank you very much in advance for your sypport.
Kind Regards,
Apostolos
Hello,
Can you please share the corresponding files like .stdp, .std with me? It seems the sections you have used are not compatible with the templates you are trying to use.
16794 Shelter with changes5 with HEB120 ROTATED AND UPN DOUBLE 100 ROOF WITH 75X55X7 ALL ANGLES3 WITH DIF POINTS IN ROOF ANTWIND FWITH WIDER ANGLES FINAL2.STD16794 Shelter with changes5 with HEB120 ROTATED AND UPN DOUBLE 100 ROOF WITH 75X55X7 ALL ANGLES3 WITH DIF POINTS IN ROOF ANTWIND FWITH WIDER ANGLES FINAL2.STDP