Good evening dear community,
I need your guidance regarding the launch and use of Ram connection interface.
Model designed in physical modeler and then analysed in analytical. As you can see on the below picture i selected the ''select all Beam-Column flange joints'' from ''select joints tab'' at the upper left side. Then i selected the smart connection and put the applicable design code where only one connection was available.. see the following pic.
I selected it and then the following message appeared.
What am i supposed to do in order to assign the connections?
Thank you very much in advance for your sypport.
Also in continuation to the above the following message is indicated.
Thanks and Regards,
BCF (Beam-Column Flange) connection will not work for these joints, as these a Beam to Column Web (BCW) joints.With regards to the crash - make sure that you are using the most recent STAAD.Pro CE version 22.10.00.153.
Answer Verified By: Apostolos Koursaris
thank you very much Modestas for your great support and your answer, always to the point.