Floor load generation

Question

Kindly refer to the model attached and reference pictures. 
 
 For FLOOR LOADS created under REFERENCE LOADS I am getting "WARNING- NO MEMBERS LOADED FOR A FLOOR LOAD GENERATION." 
 However, in the GUI the same panel is indicated as loaded for the load I am getting the warning for. I am getting a total of 14 warnings. 
 I don't know where I am mistaken. 6011.Building 2.STD

Modestas · Accepted Answer

You should not be using the exact coordinates in the Floor ranges. Instead, a minimum range should be slightly lower than the actual coordinate is and the maximum range should be a bit larger than the actual coordinate is. I.e. 
 I.e. if your X coordinates of the boundary are 6.78 and 11.304, then you should be using XRange with minimum value as 6.75 and maximum as 11.31.