I am working on a G+2 public steel building, after modeling I am unable to assign the load on LL.acn anybody rectifies this problem? all the loads assigned are done by old v8i staad pro , but in connect edition this load is not working properly. in the file, I attach only some part of the load that is being applied in LL but in the old staad pro all part is showing loading is correct .
thank you
shanu kumar vishwakarma0724.Structure1.STD
Refer to the below link for a solution. Once you change the ranges as explained in the link, the file should run correctly in STAAD.Pro CONNECT Edition version
https://communities.bentley.com/products/ram-staad/f/ram-staad-forum/235626/floor-load-generation
IT WORKS , THANK YOU SO MUCH SIR