Hello,
I am having difficulties deleting chevron braces in RAM SS. I am in the process of modifying my model (the roof layout changed therefore I do not need the braces in the long direction) when I noticed I needed to delete the braces shown in the snippet below. I cannot find an Elevation View to see these chevron braces to delete them. I had deleted the lateral beams and columns and tried putting them back in place to no avail. Nothing I do to revert back all lateral beams and columns to their original location to show an Elevation View of the frame will work. Is there any way to delete the chevron braces besides in an Elevation View?
Please advise. I do not want to start from scratch as I have already reconfigured the rest of the levels in the model. I also attached my RAM SS model to this discussion.
Thanks,
Pascual
ConRAC_CSA_DD_rev03.rss
Thank you, Seth. You and the others that reply to our many questions have always been life savers to my questions. Thank you again. And keep up the good work.
Check this: https://communities.bentley.com/products/ram-staad/w/structural_analysis_and_design__wiki/25860/deleting-a-brace-that-does-not-appear-in-elevation
Answer Verified By: Pascual Mauricio