Apply the same connection detail to set of joins in your structure

Question

Hi all, 
 I have a set of similar joints as captured below, can we apply the same connection detail to all these joints? As for now, I only can update the joint one by one by clicking on the joint number in the table on the right hand side.

Modestas · Accepted Answer

This Wiki explains the process: How to modify a group of connections at the same time in STAAD.Pro? - RAM | STAAD | ADINA Wiki - RAM | STAAD | ADINA - Bentley Communities

Modestas · Answer

When the Structural Integrity option is checked, the requirements for structural integrity are included in the design (Section 1.2, EN 1991-1-7). All buildings must satisfy certain structural integrity requirements. For some classes of buildings it will be necessary to check the connection for horizontal and vertical tying forces, used to ensure a minimum level of robustness and to prevent disproportionate collapse in the event of an accidental action affecting the structure.

Apply the same connection detail to set of joins in your structure

Top Replies