Rotation of Angle Members

I have a couple of questions concerning the rotation of singe angle members.  Which command should I use to rotate these angle members?  "Beta Angle" or "Beta 45" (or 135 or 225 or whatever your required angle is)?  I pose this question because I would have thought the results would have been the same but they are not.  The results for "Beta Angle" actually match those of an angle member modeled along its principal axis with no rotation or "Beta 0".  I also would have thought the properties for the weld design, namely Sz, Sy, CH & CV, would have changed with this "Beta Angle" command since the member end forces are no longer being applied in the same manner to the weld.  Any thoughts?

Parents
  • How do you apply wind pressure from global to local components or transformation for every direction of wind analyses?
     
  • Since for angle sections the principal axes ( and hence local axes) are not parallel to the legs, you do not need to match the alignment of the local axes for angles with the global axes because if you do so, the angle legs would not be aligned with the global axes. Rather you would want to align the legs with the global planes which is where the beta angle assignment comes into the picture. You can rotate the angle by any rotation angle about it's local x axis using a beta angle which would give you the ability to align angles as you want it to be.

    If you need to apply wind loads at certain angle to the global direction ( horizontal), there is no direct way of doing that in STAAD.Pro. The wind load needs to be resolved into two components along the two global directions and applied that way. 

    Also I would like to add that the wind load generation ( Open Structure option ) can take into account the orientation of angles when it calculates the member load. Based on the orientation of the angle section, the software would figure out the area of obstruction and calculate the udl on the member accordingly. 



Reply
  • Since for angle sections the principal axes ( and hence local axes) are not parallel to the legs, you do not need to match the alignment of the local axes for angles with the global axes because if you do so, the angle legs would not be aligned with the global axes. Rather you would want to align the legs with the global planes which is where the beta angle assignment comes into the picture. You can rotate the angle by any rotation angle about it's local x axis using a beta angle which would give you the ability to align angles as you want it to be.

    If you need to apply wind loads at certain angle to the global direction ( horizontal), there is no direct way of doing that in STAAD.Pro. The wind load needs to be resolved into two components along the two global directions and applied that way. 

    Also I would like to add that the wind load generation ( Open Structure option ) can take into account the orientation of angles when it calculates the member load. Based on the orientation of the angle section, the software would figure out the area of obstruction and calculate the udl on the member accordingly. 



Children
No Data