• Design of Solid slab (Conventional slabs)

    Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

  • Dummy beam

    Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

  • How to create a cantilever slab by using the Physical modeler?

    How to create a cantilever slab without beams in the Physical modeler in STAAD connect edition?

  • How Can I change the Horizontal position of biaxial columns?

    How Can I change the Horizontal position of biaxial columns from the center to the right side, like the below figure? I'm Using Staad pro connect edition.

  • minimum 13 stations are required for beam

    when i open mdb file of etabs 16 and designing beam its shows "minimum 13 stations are required for beam" what is the meaning of this?
Communities
Support and Services
Training and Learning
Social Media