Hi, Based on NBCC 2015 4.1.8.11 4) single storey buildings with steel or wood deck as diaphragms can have a higher fundamental period compared to 4.1.8.11 3) as seen in the snap below. However, in the current RAM frame the Ta is only based on clause…

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

Hello Everyone How can I reduce the development length bars in the beam (Figure 1-1), I'm running to get a result like this beam (figure 2-1) Figure 1-1 Figure 2-1

How do I change Mton/Cm to Kn/m

warehouse.zip wind calculation also in that folder.... try to fix this probem guys

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?

Hola; Necesito saber si es posible generar barras según las define el reglamento CIRSOC 301, como Itipo Grupo IV y Grupo V en RAM, como se ven en la imagen del link. https://www.google.com.ar/url?sa=i&rct=j&q=&esrc=s&source=images&cd=&ved=2ahUKEwjp8…

Where and how can i take in count the Friction losses of horizontal curves ? I have to calculate manually and includ in long term losses?..

I have set up a model in RAM. It is A steel frame sat on an RC base. I have run the data check and there are no errors or warnings. I have run the steel beam design and it has given me section sizes. However, every time I try to run the steel…

Is there any update coming to RAM BasePlate, or plans to include a base plate module in RAM Elements? This seems to be one of the more glaring holes in the RAM Suite.

When looking at the long term deflections in RAM Concept, not using the Long Term Load History calculations. I check the Service Design rule set and under Section analysis, I check the selector called Long Term Deflection, This appears to take the elastic…

I am using RAM Structural for a building that has dozens of different Surface loads, Line loads, and Point Loads. I have all of the various loadings tabulated in an Exel file. It is my understanding that with Data Access, there should be a way for me…

I was wondering if there is any literature on the best way to approach the design of a simple four sided moment frame building using RAM Structural System? Thanks, Scott

Is there any way to go about loading the structure with thermal loads in RAM Structural System? Currently we have two buildings that are seperated by a very small expansion joint and we are going to join them, however we would like to see what effect…

Panel Zone shear Vpz is determined. It is reduced by "Vc". I can find no discussion of this variable in any manual or in any post on this site. I have made a few attempts to recreate this assuming that it is shear in the column, but have had little luck…

Hi everyone, I have been using RAM Steel Column in the CSA S16 for the design of some WWF sections (required due to limits on column dimensions and our high loading) and are finding the Cr values (Compressive Resistance) calculated using RAM Steel…