Bentley Communities
Site
Search
User
Site
Search
User
Product Communities
RAM | STAAD | ADINA
RAM | STAAD Forum
Sign In
All tags
Slab
RAM
"model"
analysis
beam
Beam Design
Bentley Structural
Concept
Concrete Design
CONNECT Edition
design
edges
error
Eurocode
modeler
plates
RAM Structural System
STAAD
STAAD analysis
STAAD.Pro
STAAD.Pro CONNECT Edition
STAAD.Pro V8i
STAADfoundation
STAADPro
Structural
structural engineering
sye
Dummy beam
Sulaiman Ade
Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?
Answered
over 2 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum
Shear Capacity of Slab
Edward Pigozzo
Hi, In RAM concept it shows you a shear plan required for the reinforcing. I understand that these shear bars are shown over columns because of punching shear. If it is not shown over a column or a concentrated load from above, does this mean the…
Answered
over 5 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum
RAM Structural System modeler - Gable roof warehouse slab edges and decks
WILLIAM MOORHEAD
Do I need to put separate slab edges on gable roof planes on opposite sides of a ridge, and if so, then is there a trick to getting this done? I can put in one perimeter of slab edges, with one of the four edges coinciding with the beam at the ridge,…
Answered
over 5 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum
Error - No punch cutoff sections found
Liam Bryant
Hi, I'm a relatively new user and having an issue with the error message below; It is happening for all of my edge columns. I've played with the geometry, trying a flat slab, with an edge thickening and varied the punching shear "maximum search radius…
Answered
over 5 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum
View related content throughout RAM | STAAD | ADINA
More
Cancel