I noticed that steel auto drafter does not show the correct working point of beams. As seen below, WP is set at 1m from EL.2.05 which should place it at EL.3.05 however this is not the case if dimension is measured in the generated drawing. Please advise…

Dear Team Bentley, I have a curious question to ask regarding Member Size in Properties for Tapered Sections. My queries as below: 1. Why STAAD show Tapered Section with 1,2,3 etc. instead of Member Sizes like (d1-d2)xtw+2*(b1-b2)xtf1/tf2 like this…

Hello Everyone i am getting the weight of material from Steel Auto Drafter L Angle 60x60x8mm, Length 42.12 Meter & Weight 1.23 Ton but when i check with online calculator then show the weight 0.298 Ton would you pls advice what the reason

2350.Portal Frame.STD Dear All Respected When i move from model to Steel AutoDrafter then showing "Error Reading Staad File" Another issue few member property are not shown Would you pls advice how can i overcome on above issue Thanks in advanc…