staad. pro code checking-IS 800 2007(LSD) THEN THE ERROR IN THE OUTPUT FILE ***error in reading section forces for steel design from unit L16***

Hi, I'm studying the floor vibrations on a model that consisting of three floor A, B and C, despite floor A and C are symmetric, they show different ultimate acceleration because STAAD considers one of the girders only for calculating the results of…

I'm trying to model the attached floor system, and I need to make sure following points: 0- Can I draw the composite deck to cover all the floor area or do I have to draw it for every panel in the floor. because when I'm trying to cover the whole…

Good day I have modeled a structural steel frame building and analyzed it using the direct analysis method, however I have received a few warnings and I would like to know the relevant of these as well as their potential effect on my analysis results…

Good Day, I have done a seismic analysis and noticed the following note: ***NOTE: SEISMIC LOAD IS ACTING AT CENTER OF MASS FOR RIGID DIAPHRAGM. TORSION FROM STATIC ECCENTRICITY (esi) IS INCLUDED IN ANALYSIS. DYNAMIC ECCENTRICITY APPLIED = DEC -…

Good Day, I have analyzed and designed a shear wall following the ACI code in Staad and would like to clarify some results.. The shear wall design has reported Edge reinforcement, however the length of this edge or boundary zone has not been reported…