• WHAT IS MEANING OF FOLLOWING NOTE - NEAR DIAGONAL DECAY AT JOINT DIRECTION = MZ ?

    I'm getting a note after the analysis as shown below: **NOTE - NEAR DIAGONAL DECAY AT JOINT 511 DIRECTION = MZ. Even though the structure is symmetric, the support reactions of the left and right sides are differing. Please help to sort out this…
  • Utilisation Ratio different in Postprocessing UI vs Analysis Output File - STAAD Pro

    For bigger STAAD models using STAAD.Pro Connect Edition, I find that when I run analysis the Utilisation Diagram and Table in the Postprocessing Workflow UI differ from the results produced inside the Analysis Output File. For example, the apparent highest…
  • Design of Land Oil Drilling Rog

    Sir, I am a structural designer in Oil Field equipment. I design land oil rigs. I have couple of doubts. The entire Mast section is manufactured in segments due to transport constraint and assembled at site by use of PIN joints. How do I model this…
  • RE: Where are STAAD auto load combinations stored?

    Hi Please find the attached excel sheet which will generate Load combinations required for staad pro & also required report. it will reduce amount of work required to type staad load combinations Regards Mallesh N G LOAD COMBINATIONS &…
  • RE: STAAD OUTPUT formatting

    There is no way to get the data copied like that from the analysis output file into excel. Within the Analysis Output Viewer, one can use the setting below to prevent the header and footer from being printed but that is pretty much what can be done. Any…