Iam interested to know if i can design a slanting reinforced concrete beam as shown in figure below, and perform its deflection check. This can not be done in RCDC because RCDC design beams at a constant height

Iam designing a concrete slab supported on two beams,the deflection results obtained in staad pro (post procssing) are given in length unit,how do i compare these results with allowable deflection because the alowable deflection according to BS 8110 …

I have a wall tank to design, whose wall material are steel plate of 12mm.I have performed analysis but when it comes to design on assigning design property there is no option to assign parameter on plates only beam, i need a help on this