Hello, Here I m going to the attached model of my building and my problem is that when I ran this model in series 6 and staadpro ce update 7 after the analysis I'm getting the different results of R/F. you can check out the result for beam no. 149…

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

How to create a cantilever slab without beams in the Physical modeler in STAAD connect edition?

Can anyone resolve my issue. issue is i m define y range in floor load but it will automatically take x and z ranges. you can see in attached screenshot.

Hello Sir, When i am going to apply wind load on water tank than what happend it is apply on half portion of tank as you can see in the attched screenshot below. so my question is how can be apply wind on cylindrical as well as conical portio n of…

My question is when i perform analysis it will show 0 error and 0 warning but when i go to post processing mode it will show warning msg this work flow required analysis result. I didn't get why its happen 5773.COMMUNITY HALL RE 3.std . Here i attached…

When i will perform dynamic anaysis after assign property reduction factor than we got the error like this. *ERROR* STAR FILE MGR. ERROR NO. 6 DETECTED BY LIBREAD THIS ERROR MAY HAVE BEEN CAUSED BY INPUT DATA ERRORS OR PROGRAM LOGIC ERRORS. *** ERRORS…