I have model my truss and i want to add steel rod of 20mm diameter as a bracing on pipes carrying the truss,is this option available in Staad Pro Connect Edition?

I want to design this kind of steel truss in Staad Pro Connect Edition, should i run analysis in staad space or staad plane which one is correct?

Addition of partition wall load on slab should be added on analytical model in Staad Pro Connect Edition

Option for modelling,analysis and design of a project with flat slab should be added in Staad Pro Connect Edition

Design of cantilever slab in RCDC should be added and also slab supported by beams on its two sides and its other two sides free or only three sides are supported by beams and the other side free.

Iam designing a reinforced concrete ramp as a plate,the difficult iam facing is there is no BS 8110 in analytical design,and with the available BS 8007 i cant check deflection of the plate.

BS 8110 should be added currently is not available in design at analytical modeling ,the BS available for concrete is only BS 8007.

During design of beam in rcdc,if i put a check of crack width the software will not design and it gives a message written "Cannot find column [StAstTop] but if i dont check for crack width the software works perfectly.Need a help on this problem because…

I think it will be better during design in RCDC,to select the concrete grade of column separately from that of wall.Concrete grade should be divided into two parts one for columns and the other one for walls.

May you please improve the design of foundation of parametric wall in RCDC,lets say if i want my footing size to be 1500mm by 300mm depth,but the left side i want it to be 400mm from centre of wall and right side to be 1100mm from centre of wall,currently…

Improvement should be done on RC wall, during modelling on places of RC wall i don't place beam on top of the wall because the wall it self act as a beam,but when it comes to assign of floor load in places where there is no beam on RC wall the floor load…

May you add an option for choosing the strength stirrups in RCDC,by default is 250 but when i want to use stirrup of 410 its not possible to change its strength in RCDC

May you please include the design of raft foundation and combined footing in RCDC

May you please update the design of Slant beam in RCDC,as you may have a building has a certain slope from one grid to another

May you please include the design of waffle slab, ribbed slab and flat slab in rcdc

May you please add RC Designer in the next update of Staad pro CE