Whenever using Grouping for end wall columns for wind loads and applying one-way distribution the loads are taken incorrectly, I have attached the staad model showing the problem with connect edition, also when the same model is opened through an older…

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

How to create a cantilever slab without beams in the Physical modeler in STAAD connect edition?

Hello Sir RCDC is designed and Detailed all the slab one by one but I want to detail all Top and Bottom Reinforcement of the two-way slab once, what should I do.

Learn skills to best leverage your STAAD software for 3D structural analysis and design at the next STAAD Special Interest Group virtual workshop. The complimentary, one-hour session will get underway on June 21, 2018 at 1 p.m. EDT. Register now ! The…