hi

STAAD SPACE START JOB INFORMATION ENGINEER DATE 19-Nov-22 END JOB INFORMATION INPUT WIDTH 79 UNIT MMS KN JOINT COORDINATES 12 14700 6850 0; 13 19450 6850 0; 14 27450 6850 0; 15 30101 6850 0; 16 14700 6850 4200; 17 19450 6850 4200; 18 27450 6850 4200;…

PEB.RESPONSE SPECTRUM ANALYSIS.std

Hi, We are doing our final year project in the design of PEB structures. so we are using staad software to design and analysis the structure. we have received more warnings and notes like "instability at joints, weak spring added for stability, zero stiffness…

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

How to rectify this failure known as 'Detailing failure' in RCDC

Sir, the bottom chord of my trusses is failing due to compression at wind load upward alone load case 5. But i want to ignore this case which will never happen alone due to dead load of 1 kn/m2 on the roof.I want to check my steel with load combinations…

Does anybody designed Gantry crane using STAAD.Pro? Can anybody explain how can i assign whole surface of the rail on the ground as fixed? do i need to divide the rail in to small parts and assigned those nodes as fixed? or do i need to design Gantry…

Hello, I´m designing two small guardhouses in STAAD.Pro V8i SS5, both are RC structures with slab foundations, they are almost equal in principal geometry, loading and sections, the only thing that changes considerably from one model to the other is the…

I am trying to model a Elevated steel water tank with bracing for analysis in STAAD.Pro. While modelling the structure I've encountered a problem and would like your help. The problem is: While the beam offset works perfectly for modelling a beam…

Dear sir, I designed a structure by using both method.in first method i deaigned it by composite beam method.and in second method i do it with composite deck.but by using composite beams giving lower utilization ratio than composite deck method.can…

I am analysing an RCC box girder for which some peculiar tapered sections have to be created. I created a tapered rectangular section in AutoCAD 2014. I used polyline to create the 2D and then extruded it to make it a solid 3D section. Now when I import…

Is there any option to get report for the tension & compression flange stress ratio of built-up I-section for the critical load cases.

Dear sir , Kindly give me direction how I can check the deflection for the specific beams.stad file and drawing is attached.consultant want vibration check for specific beam.thanks. PDF STORE.std2.std

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?