You are currently reviewing an older revision of this page.
User table sections when defined using the graphic user interface are getting written in the input command file with a UNIT command within the user table definition block as shown next
START USER TABLE
UNIT INCHES KIP
1112.25 80 0 47 0 995062 89512 27715.6 23232.6 3809.02 525.421 550.813 -
30641.9 7257.83 8.04422e+07 80
Subsequently the software is incorrectly reading all the properties in meter units. This is resulting in incorrect properties being considered for the analysis and design and also incorrect display of the structure in 3D.
Open the STAAD.Pro command file in the editor and move the UNIT INCHES KIP command in the user table definition so that it comes just before the START USER TABLE line, as shown below
Once the data is Saved from within the editor, the file should work without any problem.
The problem will be addressed in the STAAD.Pro Connect Edition Update 4.