Civil Cell Junction insert cause crashes

Can you forward me your data?  In theory you can place the cell on referenced geometry.

I have seen where abrupt change in geometry( i.e. an EoP that uses a point control suddenly extends outward between stations) will cause a failure if that change is at the cell placement point. In this case the cell can be placed by deactivating point control and re activating after placement. This is good to see all the dynamics and rules update moving everything into the correct position

Another idea is to open the DGNLIB that contains the civil cell.  I have previously experienced a crash when the civil cell is not "Valid for Placement".  The crash I saw happened immediately when I clicked on the Place Civil Cell Tool.

You can read more about the Valid for Placement setting at the following link:

http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki/17107.civil-cell-valid-for-placement-setting.aspx

Another idea is to open the DGNLIB that contains the civil cell.  I have previously experienced a crash when the civil cell is not "Valid for Placement".  The crash I saw happened immediately when I clicked on the Place Civil Cell Tool.

You can read more about the Valid for Placement setting at the following link:

http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki/17107.civil-cell-valid-for-placement-setting.aspx