Overlapping when creating surface using Roadway Designer "Inroads SS2"

Question

Hi 
 After I run the template and create surface using Inroads SS2 "Roadway Designer" , I got overlapping as shown in the picture between the Right of Way and Edge of Pavement , as the template is picking points from the Right of Way and picking from the edge of pavement and again picking point from the Right of way. How I can solve this. 
 
 Thank you

Sanders Thomas · Answer

Hi Mahmoud, 
 
Based on the image only this issue is somewhat difficult analyze; however, if your end condition Target Type is set to Style (and not Feature maybe), ensure that your Right of Way and Edge of Pavement styles are not the same. 
 
You may also consider selecting Remove Loops and Add Transverse Features within the Create Surface command as you create your surface. 
 
Again, based on the image only, I can only make limited assumptions. 
 
Thanks, 
Sanders