Civil Geometry crash sequence

Question

MicroStation 08.11.09.608 
 GEOPAK 08.11.09.722 
 This sequence crashes MicroStation every time in any file on any computer I've tried. 
 Civil Tools / Horizontal Geometry / Arc Between Points Method: Start\End|Pass-through Snap to end of first element using Tangent Point snap Snap to second element using Tangent snap 
 
 Can anyone replicate this?

Vern Danforth · Accepted Answer

Mike , 
 
 I was able to re-create the problem you have reported, yes. ... try this as a work around! 
 1. Use the select tool to highlight the tangent bearing angle of the first element you want to begin the arc.Copy the angle using, CNTL C 
 
 2. Use Civil Tools >Horizontal Geometry >Arc to Element tool 
 
 a. Select the element tangent line to LAND on 
 b. set or lock the offset to zero 
 c. Toggle to the End Tangent Method 
 d. Paste the angle from step 2 CNTR V , enter to lock 
 e. snap to the BEGIN point of the ARC 
 
 f. Trim back

Ricardo Villegas · Answer

I replicated the issue, I am working on it, please I recommended for now to use Arc to Element tool (copy the bearing from the first element), then select the second element(Tangent), set offset zero, check on End Tangent method, paste the bearing from first element, press Enter, then snap of the begin of arc, then select the other element to trim, basically is like Vern Danforth show in his comment.