GEOPAK CORRIDOR MODELER CROSS SECTION LABELING ERROR.

Did you try to delete the Geopak resources files (*.rsc), also I recommended to upgrade Geopak to the latest version 08.11.07.615

I cannot open the CM cross section labeler. I don't get an error. The tool simply does not open. I'm running SS3 08.11.09.608 and Geopak 08.11.07.566. I point to the XSLabeler.mvba through a pcf variable. Other users with the same version installation can open the labeler. Thanks

Hi Bobby! Long time no see. I just ran into the same error. I am running version. 08.11.07.615

I was able to fix the error by running the latest version of the "geopakcom.exe".

You can try a few things to potentially solve this problem.

1. If you are not using a select series 2 version 08.11.07.536 or higher you may have encountered a defect attributed to having two(2) GPK files in the COGO directory.

2. The GEOPAKCOM did not register properly on your machine. So you can go to the BIN folder where you installed the software and as the administrator of your machine you can execute the file 'geopakcom.exe' This should register the geopakcom and you may be able to run now.

3. You could also try the following but you do need to have full control set in your user privleges

(1.) Close all DGN files

(2.) Bring up the dos prompt and change directory ("cd") to the following location (may be slightly different on your computer):

cd C:\Program Files (x86)\Common Files\Bentley Shared\GEOPAK\

(3.) Key-In "REGSVR32 BentleyControls.ocx" and press Enter.

You should get a message "DllRegistryServer in BentleyControls.ocx succeeded"

(4.) Now exit the dos prompt, go back into your DGN file and try again